4 March 2018

A fairly calm work-week, until the big winds came. We didn’t lose power at the office, nor at home. But plenty of blinking lights and brown-outs, at both locations. ‘Round about 1 PM, Marcia called and said there were bits blowing off the house, and … problems with the fence. There was plenty of coverage at the office, so I came home. The house issue was limited to some segments of the aluminum soffit under the second story eaves in front. The fence issues, however… On the southeast perimeter, some fencing had come loose from one post, and another post is failing. I’ve got that braced pending further work, later in the spring. The northwest segment of fence saw a more dramatic failure:

Fence failed during windstorm - a post snapped off, and one 8' section blown about 35 feet into the yard.

Fence failed during windstorm

There, the fence failed during windstorm – a post snapped off, and one 8′ section blown about 35 feet into the yard. Not much I could do about that until the winds died down. Saturday, we were already committed to helping out with spring cleaning and reorganization down at the theatre. That left today for repairs.

This morning, after shopping, I headed down to the Home Depot to get what I needed: a couple of bags of concrete and six eight-foot long 2×4 pressure treated. I had a spare post, and just enough fence uprights left over from the big fence project of a couple of years back. Once home, I geared up and started by cutting the two old fence sections in half, for later ease of handling. Then I started working with the shovel, pick axe, and trowel, clearing enough of the minimal concrete and mucky clay from around the stump of the old post, that I might extract said stump. All in on that part of the work – just over an hour. Using my post hold digger, I got down to about 36″ of clear hole, and prepared for the new post. Marcia came out and held it while I trued up the post using a small level and string line. Then I braced the post, and got ready to fill with concrete and backfill from the hole digging process.

New fence post in hole, ready for concrete.

Post in hole, ready for concrete.

Once I’d set the post, I left it to set up for a bit, and got the ladder out to go deal with the soffit issue. The soffit panels were interesting in their storm dispersal. Four of them had blown into the yard of the house just south of us, were collected by that neighbor and saved for us. The fifth segment had executed a Mary Poppins maneuver: Across the street and about 4 houses up – three to four hundred feet away. I spotted it by accident while walking the dog on Saturday. But all in, an easy fix. It was trivial for me to reach the place where the panels needed to be, while standing on the front porch roof. 45 minute put that chore to bed, and I was back at the fence work.

Using a string and measuring tape, I set the top, middle, and bottom rails for the two new 8′ sections of fence. They’re well secured with angle brackets and 3″ coated screws. Then I started setting up for nailing up the fencing proper. By 3:50 PM, I was attaching the first board. By 4:45, the work was done, except for the cleanup.

New fence sections done

New fence sections done

A pneumatic nail gun loaded with 1-3/4″ galvanized 18 gauge stock makes quick work of the job. A couple of pieces needed trimming at the end of each section. All-in-all, a good day’s work. Exhausting, but good.

*       *       *

On the exercise front, I had a good, good February. I met all the goals for exercise, workouts, and active calorie burn, every day of the month. Hard to do, but making progress feels good.

*       *       *

DoD announced no new casualties in the last week.

Bookmark the permalink.

About bilborg

I am who I am, there's plenty of data on this site to tell you more. Briefly, I'm a husband, computer geek, avid reader, gardener, and builder of furniture.

Leave a Reply

Your email address will not be published. Required fields are marked *